From: "Hogander, Jouni" <jouni.hogander@intel.com>
To: "Manna, Animesh" <animesh.manna@intel.com>,
"intel-gfx@lists.freedesktop.org"
<intel-gfx@lists.freedesktop.org>
Cc: "dri-devel@lists.freedesktop.org"
<dri-devel@lists.freedesktop.org>,
"Murthy, Arun R" <arun.r.murthy@intel.com>,
"Nikula, Jani" <jani.nikula@intel.com>
Subject: Re: [PATCH v4 4/6] drm/i915/alpm: Add compute config for lobf
Date: Mon, 13 May 2024 07:31:46 +0000 [thread overview]
Message-ID: <f45895701e1a6d80b163fe89b3fe5995eb38bf90.camel@intel.com> (raw)
In-Reply-To: <20240509053155.327071-5-animesh.manna@intel.com>
On Thu, 2024-05-09 at 11:01 +0530, Animesh Manna wrote:
> Link Off Between Active Frames, is a new feature for eDP
> that allows the panel to go to lower power state after
> transmission of data. This is a feature on top of ALPM, AS SDP.
> Add compute config during atomic-check phase.
>
> v1: RFC version.
> v2: Add separate flag for auxless-alpm. [Jani]
> v3:
> - intel_dp->lobf_supported replaced with crtc_state->has_lobf.
> [Jouni]
> - Add DISPLAY_VER() check. [Jouni]
> - Modify function name of get_aux_less_status. [Jani]
> v4: Add enum alpm_mode to hold the aux-wake/less capability.
>
> Signed-off-by: Animesh Manna <animesh.manna@intel.com>
> ---
> drivers/gpu/drm/i915/display/intel_alpm.c | 58
> +++++++++++++++++++
> drivers/gpu/drm/i915/display/intel_alpm.h | 5 ++
> .../drm/i915/display/intel_display_types.h | 11 ++++
> drivers/gpu/drm/i915/display/intel_dp.c | 4 ++
> 4 files changed, 78 insertions(+)
>
> diff --git a/drivers/gpu/drm/i915/display/intel_alpm.c
> b/drivers/gpu/drm/i915/display/intel_alpm.c
> index ee6c2a959f09..5979eab1f2e0 100644
> --- a/drivers/gpu/drm/i915/display/intel_alpm.c
> +++ b/drivers/gpu/drm/i915/display/intel_alpm.c
> @@ -11,6 +11,23 @@
> #include "intel_dp_aux.h"
> #include "intel_psr_regs.h"
>
> +enum alpm_mode intel_alpm_get_capability(struct intel_dp *intel_dp)
> +{
> + u8 alpm_caps = 0;
> +
> + if (drm_dp_dpcd_readb(&intel_dp->aux, DP_RECEIVER_ALPM_CAP,
> + &alpm_caps) != 1)
> + return ALPM_INVALID;
> +
> + if (alpm_caps & DP_ALPM_CAP)
> + return ALPM_AUX_WAKE;
> +
> + if (alpm_caps & DP_ALPM_AUX_LESS_CAP)
> + return ALPM_AUX_LESS;
> +
> + return ALPM_NOT_SUPPORTED;
> +}
This will always return ALPM_AUX_WAKE if both are supported. I don't
think this is what you want?
You could add alpm_dpcd into intel_dp. Then for this purpose add
aux_wake_supported() and aux_less_wake_supported()?
BR,
Jouni Högander
> +
> /*
> * See Bspec: 71632 for the table
> *
> @@ -242,6 +259,47 @@ bool intel_alpm_compute_params(struct intel_dp
> *intel_dp,
> return true;
> }
>
> +void intel_alpm_compute_lobf_config(struct intel_dp *intel_dp,
> + struct intel_crtc_state
> *crtc_state,
> + struct drm_connector_state
> *conn_state)
> +{
> + struct drm_i915_private *i915 = dp_to_i915(intel_dp);
> + struct drm_display_mode *adjusted_mode = &crtc_state-
> >hw.adjusted_mode;
> + int waketime_in_lines, first_sdp_position;
> + int context_latency, guardband;
> +
> + if (!intel_dp_is_edp(intel_dp))
> + return;
> +
> + if (DISPLAY_VER(i915) < 20)
> + return;
> +
> + if (!intel_dp_as_sdp_supported(intel_dp))
> + return;
> +
> + if (crtc_state->has_psr)
> + return;
> +
> + if (intel_dp->alpm_parameters.mode == ALPM_INVALID ||
> + intel_dp->alpm_parameters.mode == ALPM_NOT_SUPPORTED)
> + return;
> +
> + if (!intel_alpm_compute_params(intel_dp, crtc_state))
> + return;
> +
> + context_latency = adjusted_mode->crtc_vblank_start -
> adjusted_mode->crtc_vdisplay;
> + guardband = adjusted_mode->crtc_vtotal -
> + adjusted_mode->crtc_vdisplay - context_latency;
> + first_sdp_position = adjusted_mode->crtc_vtotal -
> adjusted_mode->crtc_vsync_start;
> + if (intel_dp->alpm_parameters.mode == ALPM_AUX_LESS)
> + waketime_in_lines = intel_dp-
> >alpm_parameters.io_wake_lines;
> + else
> + waketime_in_lines = intel_dp-
> >alpm_parameters.fast_wake_lines;
> +
> + crtc_state->has_lobf = (context_latency + guardband) >
> + (first_sdp_position + waketime_in_lines);
> +}
> +
> static void lnl_alpm_configure(struct intel_dp *intel_dp)
> {
> struct drm_i915_private *dev_priv = dp_to_i915(intel_dp);
> diff --git a/drivers/gpu/drm/i915/display/intel_alpm.h
> b/drivers/gpu/drm/i915/display/intel_alpm.h
> index c45d078e5a6b..80c8a66b34af 100644
> --- a/drivers/gpu/drm/i915/display/intel_alpm.h
> +++ b/drivers/gpu/drm/i915/display/intel_alpm.h
> @@ -10,9 +10,14 @@
>
> struct intel_dp;
> struct intel_crtc_state;
> +struct drm_connector_state;
>
> +enum alpm_mode intel_alpm_get_capability(struct intel_dp *intel_dp);
> bool intel_alpm_compute_params(struct intel_dp *intel_dp,
> struct intel_crtc_state *crtc_state);
> +void intel_alpm_compute_lobf_config(struct intel_dp *intel_dp,
> + struct intel_crtc_state
> *crtc_state,
> + struct drm_connector_state
> *conn_state);
> void intel_alpm_configure(struct intel_dp *intel_dp);
>
> #endif
> diff --git a/drivers/gpu/drm/i915/display/intel_display_types.h
> b/drivers/gpu/drm/i915/display/intel_display_types.h
> index e81fd71ce57b..79e9e543020b 100644
> --- a/drivers/gpu/drm/i915/display/intel_display_types.h
> +++ b/drivers/gpu/drm/i915/display/intel_display_types.h
> @@ -1405,6 +1405,9 @@ struct intel_crtc_state {
>
> /* for loading single buffered registers during vblank */
> struct drm_vblank_work vblank_work;
> +
> + /* LOBF flag */
> + bool has_lobf;
> };
>
> enum intel_pipe_crc_source {
> @@ -1715,6 +1718,13 @@ struct intel_psr {
> u8 entry_setup_frames;
> };
>
> +enum alpm_mode {
> + ALPM_INVALID,
> + ALPM_AUX_WAKE,
> + ALPM_AUX_LESS,
> + ALPM_NOT_SUPPORTED
> +};
> +
> struct intel_dp {
> i915_reg_t output_reg;
> u32 DP;
> @@ -1835,6 +1845,7 @@ struct intel_dp {
> u8 fast_wake_lines;
>
> /* LNL and beyond */
> + enum alpm_mode mode;
> u8 check_entry_lines;
> u8 silence_period_sym_clocks;
> u8 lfps_half_cycle_num_of_syms;
> diff --git a/drivers/gpu/drm/i915/display/intel_dp.c
> b/drivers/gpu/drm/i915/display/intel_dp.c
> index 486361eb0070..df423a33f6fc 100644
> --- a/drivers/gpu/drm/i915/display/intel_dp.c
> +++ b/drivers/gpu/drm/i915/display/intel_dp.c
> @@ -48,6 +48,7 @@
> #include "i915_drv.h"
> #include "i915_irq.h"
> #include "i915_reg.h"
> +#include "intel_alpm.h"
> #include "intel_atomic.h"
> #include "intel_audio.h"
> #include "intel_backlight.h"
> @@ -3000,6 +3001,7 @@ intel_dp_compute_config(struct intel_encoder
> *encoder,
> intel_vrr_compute_config(pipe_config, conn_state);
> intel_dp_compute_as_sdp(intel_dp, pipe_config);
> intel_psr_compute_config(intel_dp, pipe_config, conn_state);
> + intel_alpm_compute_lobf_config(intel_dp, pipe_config,
> conn_state);
> intel_dp_drrs_compute_config(connector, pipe_config,
> link_bpp_x16);
> intel_dp_compute_vsc_sdp(intel_dp, pipe_config, conn_state);
> intel_dp_compute_hdr_metadata_infoframe_sdp(intel_dp,
> pipe_config, conn_state);
> @@ -6615,6 +6617,8 @@ static bool intel_edp_init_connector(struct
> intel_dp *intel_dp,
>
> intel_pps_init_late(intel_dp);
>
> + intel_dp->alpm_parameters.mode =
> intel_alpm_get_capability(intel_dp);
> +
> return true;
>
> out_vdd_off:
next prev parent reply other threads:[~2024-05-13 7:35 UTC|newest]
Thread overview: 9+ messages / expand[flat|nested] mbox.gz Atom feed top
2024-05-09 5:31 [PATCH v4 0/6] Link off between frames for edp Animesh Manna
2024-05-09 5:31 ` [PATCH v4 1/6] drm/i915/alpm: Move alpm parameters from intel_psr Animesh Manna
2024-05-09 5:31 ` [PATCH v4 2/6] drm/i915/alpm: Move alpm related code to a new file Animesh Manna
2024-05-09 5:31 ` [PATCH v4 3/6] drm/display: Add missing aux less alpm wake related bits Animesh Manna
2024-05-09 5:31 ` [PATCH v4 4/6] drm/i915/alpm: Add compute config for lobf Animesh Manna
2024-05-13 7:31 ` Hogander, Jouni [this message]
2024-05-13 11:22 ` Manna, Animesh
2024-05-09 5:31 ` [PATCH v4 5/6] drm/i915/alpm: Enable lobf from source in ALPM_CTL Animesh Manna
2024-05-09 5:31 ` [PATCH v4 6/6] drm/i915/alpm: Add debugfs for LOBF Animesh Manna
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=f45895701e1a6d80b163fe89b3fe5995eb38bf90.camel@intel.com \
--to=jouni.hogander@intel.com \
--cc=animesh.manna@intel.com \
--cc=arun.r.murthy@intel.com \
--cc=dri-devel@lists.freedesktop.org \
--cc=intel-gfx@lists.freedesktop.org \
--cc=jani.nikula@intel.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for read-only IMAP folder(s) and NNTP newsgroup(s).