messages from 2024-03-22 08:01:52 to 2024-04-09 15:10:43 UTC [more...]
[PATCH 0/3] Fix up qcom,halt-regs definition in various schemas
2024-04-09 15:10 UTC (8+ messages)
` [PATCH 1/3] dt-bindings: remoteproc: qcom,qcs404-cdsp-pil: Fix qcom,halt-regs definition
` [PATCH 2/3] dt-bindings: remoteproc: qcom,sc7280-wpss-pil: "
` [PATCH 3/3] dt-bindings: remoteproc: qcom,sdm845-adsp-pil: "
[PATCH v3 00/25] imx258 improvement series
2024-04-09 14:12 UTC (68+ messages)
` [PATCH v3 01/25] media: i2c: imx258: Remove unused defines
` [PATCH v3 02/25] media: i2c: imx258: Make image geometry meet sensor requirements
` [PATCH v3 03/25] media: i2c: imx258: Disable digital cropping on binned modes
` [PATCH v3 04/25] media: i2c: imx258: Remove redundant I2C writes
` [PATCH v3 05/25] media: i2c: imx258: Add regulator control
` [PATCH v3 06/25] media: i2c: imx258: Make V4L2_CID_VBLANK configurable
` [PATCH v3 07/25] media: i2c: imx258: Split out common registers from the mode based ones
` [PATCH v3 08/25] media: i2c: imx258: Add support for 24MHz clock
` [PATCH v3 09/25] media: i2c: imx258: Add support for running on 2 CSI data lanes
` [PATCH v3 10/25] media: i2c: imx258: Follow normal V4L2 behaviours for clipping exposure
` [PATCH v3 11/25] media: i2c: imx258: Add get_selection for pixel array information
` [PATCH v3 12/25] media: i2c: imx258: Allow configuration of clock lane behaviour
` [PATCH v3 13/25] media: i2c: imx258: Correct max FRM_LENGTH_LINES value
` [PATCH v3 14/25] media: i2c: imx258: Issue reset before starting streaming
` [PATCH v3 15/25] media: i2c: imx258: Set pixel_rate range to the same as the value
` [PATCH v3 16/25] media: i2c: imx258: Support faster pixel rate on binned modes
` [PATCH v3 17/25] dt-bindings: media: imx258: Rename to include vendor prefix
` [PATCH v3 18/25] dt-bindings: media: imx258: Add alternate compatible strings
` [PATCH v3 19/25] media: i2c: imx258: Change register settings for variants of the sensor
` [PATCH v3 20/25] media: i2c: imx258: Make HFLIP and VFLIP controls writable
` [PATCH v3 21/25] drivers: media: i2c: imx258: Use macros
` [PATCH v3 22/25] dt-bindings: media: imx258: Add binding for powerdown-gpio
` [PATCH v3 23/25] drivers: media: i2c: imx258: Add support for powerdown gpio
` [PATCH v3 24/25] drivers: media: i2c: imx258: Add support for reset gpio
` [PATCH v3 25/25] media:i2c: imx258: Use v4l2_link_freq_to_bitmap helper
[PATCH v3 1/2] dt-bindings: arm: qcom: Add Motorola Moto G (2013)
2024-04-09 13:39 UTC (4+ messages)
` [PATCH v3 2/2] ARM: dts: qcom: Add support for "
` (subset) [PATCH v3 1/2] dt-bindings: arm: qcom: Add "
[PATCH 0/2] Fix msm8974 apcs syscon compatible
2024-04-09 12:21 UTC (7+ messages)
` [PATCH 1/2] dt-bindings: mailbox: qcom: Add MSM8974 APCS compatible
` [PATCH 2/2] ARM: dts: qcom: msm8974: Use proper compatible for APCS syscon
[PATCHv3 1/2] dt-bindings: usb: typec: anx7688: start a binding document
2024-04-09 11:04 UTC (15+ messages)
` [PATCHv3 2/2] usb: typec: anx7688: Add driver for ANX7688 USB-C HDMI bridge
[PATCH 0/2] Allow gpio-hog nodes in qcom,pmic-gpio bindings (& dt fixup)
2024-04-09 6:41 UTC (6+ messages)
` [PATCH 1/2] dt-bindings: pinctrl: qcom,pmic-gpio: Allow gpio-hog nodes
` [PATCH 2/2] ARM: dts: qcom: msm8974-hammerhead: Update gpio hog node name
[PATCH] dt-bindings: iio: imu: mpu6050: Improve i2c-gate disallow list
2024-04-09 6:36 UTC (3+ messages)
[PATCH 0/2] Small fixes for MSM8974 SoC dtsi
2024-04-08 1:37 UTC (2+ messages)
[PATCH] Documentation: ABI: document in_temp_input file
2024-04-06 17:47 UTC (3+ messages)
[PATCH] ARM: dts: qcom: msm8974-sony-shinano: Enable vibrator
2024-04-06 16:07 UTC (2+ messages)
[PATCH v2 0/3] Split sony-castor into shinano-common and add Sony Xperia Z3
2024-04-04 21:23 UTC (2+ messages)
` (subset) "
[PATCH 0/2] Add Inline Crypto Engine for SC7280 UFS
2024-04-04 21:23 UTC (4+ messages)
` [PATCH 1/2] dt-bindings: crypto: ice: Document sc7280 inline crypto engine
` (subset) [PATCH 0/2] Add Inline Crypto Engine for SC7280 UFS
[PATCH 1/1] clk: qcom: smd-rpm: Restore msm8976 num_clk
2024-04-04 21:22 UTC (3+ messages)
` (subset) "
[PATCH v9 0/9] Initial Marvell PXA1908 support
2024-04-03 14:15 UTC (11+ messages)
` [PATCH v9 1/9] clk: mmp: Switch to use struct u32_fract instead of custom one
` [PATCH v9 2/9] dt-bindings: pinctrl: pinctrl-single: add marvell,pxa1908-padconf compatible
` [PATCH v9 3/9] pinctrl: single: "
` [PATCH v9 4/9] dt-bindings: clock: Add Marvell PXA1908 clock bindings
` [PATCH v9 5/9] clk: mmp: Add Marvell PXA1908 clock driver
` [PATCH v9 6/9] dt-bindings: marvell: Document PXA1908 SoC
` [PATCH v9 7/9] arm64: Kconfig.platforms: Add config for Marvell PXA1908 platform
` [PATCH v9 8/9] arm64: dts: Add DTS for Marvell PXA1908 and samsung,coreprimevelte
` [PATCH v9 9/9] MAINTAINERS: add myself as Marvell PXA1908 maintainer
[PATCH v2 0/3] Add sy7802 flash led driver
2024-04-02 16:22 UTC (7+ messages)
` [PATCH v2 1/3] dt-bindings: leds: Add Silergy SY7802 flash LED
` [PATCH v2 2/3] leds: sy7802: Add support for Silergy SY7802 flash LED controller
` [PATCH v2 3/3] arm64: dts: qcom: msm8939-longcheer-l9100: Add rear flash
[PATCH v2 0/4] MSM8976 MDSS/GPU/WCNSS support
2024-04-02 10:26 UTC (6+ messages)
` [PATCH v2 1/4] arm64: dts: qcom: msm8976: Add IOMMU nodes
` [PATCH v2 2/4] arm64: dts: qcom: msm8976: Add MDSS nodes
` [PATCH v2 3/4] arm64: dts: qcom: msm8976: Add Adreno GPU
` [PATCH v2 4/4] arm64: dts: qcom: msm8976: Add WCNSS node
[PATCH v5 0/3] Add UFS host controller and Phy nodes for sc7280
2024-04-02 4:06 UTC (7+ messages)
` [PATCH v5 2/3] arm64: dts: qcom: sc7280: Add UFS nodes for sc7280 soc
[PATCH 0/5] initial support for Marvell 88PM886 PMIC
2024-03-31 10:46 UTC (6+ messages)
` [PATCH 1/5] dt-bindings: mfd: add entry "
` [PATCH 2/5] mfd: add driver "
` [PATCH 3/5] regulator: add regulators "
` [PATCH 4/5] input: add onkey "
` [PATCH 5/5] MAINTAINERS: add myself "
[PATCH v2 0/3] DisplayPort support for SM6350/SM7225
2024-03-30 11:49 UTC (6+ messages)
` [PATCH v2 1/3] dt-bindings: display: msm: dp-controller: document SM6350 compatible
` [PATCH v2 2/3] dt-bindings: display: msm: sm6350-mdss: document DP controller subnode
` [PATCH v2 3/3] arm64: dts: qcom: sm6350: Add DisplayPort controller
[PATCH v2 0/3] Add TCPM support for PM7250B and Fairphone 4
2024-03-29 12:26 UTC (4+ messages)
` [PATCH v2 1/3] arm64: dts: qcom: pm7250b: Add node for PMIC VBUS booster
` [PATCH v2 2/3] arm64: dts: qcom: pm7250b: Add a TCPM description
` [PATCH v2 3/3] arm64: dts: qcom: sm7225-fairphone-fp4: Enable USB role switching
[PATCH 0/3] DisplayPort support for SM6350/SM7225
2024-03-28 20:52 UTC (8+ messages)
` [PATCH 1/3] dt-bindings: display: msm: dp-controller: document SM8250 compatible
` [PATCH 2/3] dt-bindings: display: msm: sm6350-mdss: document DP controller subnode
` [PATCH 3/3] arm64: dts: qcom: sm6350: Add DisplayPort controller
[PATCH] drm/msm/adreno: Set highest_bank_bit for A619
2024-03-28 8:02 UTC
[PATCH RFT] arm64: dts: qcom: sm8350: Reenable crypto & cryptobam
2024-03-27 21:34 UTC (6+ messages)
[PATCH v2 1/2] dt-bindings: arm: qcom: Add Motorola Moto G (2013)
2024-03-27 19:50 UTC (3+ messages)
` [PATCH v2 2/2] ARM: dts: qcom: Add support for "
[RFC PATCH 0/1] Split Adreno schemas
2024-03-27 9:20 UTC (3+ messages)
` [RFC PATCH 1/1] dt-bindings: display/msm: gpu: Split Adreno schemas into separate files
[PATCH 1/2] dt-bindings: arm: qcom: Add Motorola Moto G (2013)
2024-03-26 10:10 UTC (7+ messages)
` [PATCH 2/2] ARM: dts: qcom: Add support for "
[PATCH 0/5] Add TCPM support for PM7250B and Fairphone 4
2024-03-25 17:44 UTC (16+ messages)
` [PATCH 1/5] dt-bindings: regulator: qcom,usb-vbus-regulator: Add PM7250B compatible
` [PATCH 2/5] dt-bindings: usb: qcom,pmic-typec: Add support for the PM7250B PMIC
` [PATCH 3/5] arm64: dts: qcom: pm7250b: Add node for PMIC VBUS booster
` [PATCH 4/5] arm64: dts: qcom: pm7250b: Add a TCPM description
` [PATCH 5/5] arm64: dts: qcom: sm7225-fairphone-fp4: Enable USB role switching
` (subset) [PATCH 0/5] Add TCPM support for PM7250B and Fairphone 4
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for read-only IMAP folder(s) and NNTP newsgroup(s).