On Tue, 23 Jun 2020, Philippe Mathieu-Daudé wrote:
> Since its introduction in commit 6fc7f77fd2 i2c_start_transfer()
> uses incorrectly the direction of the transfer. Fix it now.
>
> Fixes: 6fc7f77fd2 ("introduce aux-bus")
> Reported-by: BALATON Zoltan <balaton@eik.bme.hu>
> Suggested-by: BALATON Zoltan <balaton@eik.bme.hu>

One of the above is probably enough, maybe Reported-by because I wasn't 
sure what's the solution. I'm also happy with your changes to the whole 
series, thanks for fixing it.

Regards,
BALATON Zoltan

> Signed-off-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
> ---
> RFC because untested (probably never was anyway)
> Cc: Frederic Konrad <konrad@adacore.com>
> Cc: Alistair Francis <alistair@alistair23.me>
> Cc: Peter Maydell <peter.maydell@linaro.org>
> ---
> hw/misc/auxbus.c | 6 +++---
> 1 file changed, 3 insertions(+), 3 deletions(-)
>
> diff --git a/hw/misc/auxbus.c b/hw/misc/auxbus.c
> index cef0d0d6d0..dc4a5dd10d 100644
> --- a/hw/misc/auxbus.c
> +++ b/hw/misc/auxbus.c
> @@ -141,7 +141,7 @@ AUXReply aux_request(AUXBus *bus, AUXCommand cmd, uint32_t address,
>             i2c_end_transfer(i2c_bus);
>         }
>
> -        if (i2c_start_transfer(i2c_bus, address, is_write)) {
> +        if (i2c_start_transfer(i2c_bus, address, !is_write)) {
>             ret = AUX_I2C_NACK;
>             break;
>         }
> @@ -172,7 +172,7 @@ AUXReply aux_request(AUXBus *bus, AUXCommand cmd, uint32_t address,
>             /*
>              * No transactions started..
>              */
> -            if (i2c_start_transfer(i2c_bus, address, is_write)) {
> +            if (i2c_start_transfer(i2c_bus, address, !is_write)) {
>                 break;
>             }
>         } else if ((address != bus->last_i2c_address) ||
> @@ -181,7 +181,7 @@ AUXReply aux_request(AUXBus *bus, AUXCommand cmd, uint32_t address,
>              * Transaction started but we need to restart..
>              */
>             i2c_end_transfer(i2c_bus);
> -            if (i2c_start_transfer(i2c_bus, address, is_write)) {
> +            if (i2c_start_transfer(i2c_bus, address, !is_write)) {
>                 break;
>             }
>         }
>