* boot vmlinux trouble
@ 1999-01-09 5:29 Chad Carlin
1999-01-10 0:23 ` ralf
0 siblings, 1 reply; 2+ messages in thread
From: Chad Carlin @ 1999-01-09 5:29 UTC (permalink / raw
To: linux
Sorry this is a little long but I thought it would be best to give you as much information as I could.
Thanks in advance.
Chad
It appears that I am getting the kernel to boot OK. It seems that I am having problems with NFS. Can you tell from this info what might be wrong with my config.
>> boot bootp():vmlinux
130768+22320+3184+341792+48560d+4604+6816 entry: 0x8bfa60d0
Obtaining vmlinux from server marvin2
PROMLIB: SGI ARCS firmware Version 1 Revision 10
PROMLIB: Total free ram 65814528 bytes (64272K,62MB)
ARCH: SGI-IP22
CPU: MIPS-R4400 FPU<MIPS-R4400FPC> ICACHE DCACHE SCACHE
Loading R4000 MMU routines.
CPU revision is: 00000460
Primary instruction cache 16kb, linesize 16 bytes)
Primary data cache 16kb, linesize 16 bytes)
Secondary cache sized at 1024K linesize 128
Linux version 2.1.100 (root@alex3.med.iacnet.com) (gcc version 2.7.2) #29 Thu Jul 9 22:19:39 EDT 1998
MC: SGI memory controller Revision 3
calculating r4koff... 000f443e(1000510)
zs0: console input
zs0: console I/O
Calibrating delay loop... 99.94 BogoMIPS
Memory: 60364k/196116k available (1216k kernel code, 2684k data)
Swansea University Computer Society NET3.039 for Linux 2.1
NET3: Unix domain sockets 0.16 for Linux NET3.038.
Swansea University Computer Society TCP/IP for NET3.037
IP Protocols: ICMP, UDP, TCP
Checking for 'wait' instruction... unavailable.
POSIX conformance testing by UNIFIX
Starting kswapd v 1.5
Adv: about to run setup()
SGI Zilog8530 serial driver version 1.00
tty00 at 0xbfbd9838 (irq = 21) is a Zilog8530
tty01 at 0xbfbd9830 (irq = 21) is a Zilog8530
Ramdisk driver initialized : 16 ramdisks of 4096K size
loop: registered device at major 7
WD93: Driver version 1.25 compiled on Jul 7 1998 at 16:59:57
debug_flags=0x00
wd33c93-0: chip=WD33c93B/13 no_sync=0xff no_dma=0scsi0 : SGI WD93
scsi : 1 host.
sending SDTR 0103013f0csync_xfer=2c Vendor: IBM Model: DCAS-32160 Rev: S65A
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 1, lun 0
sending SDTR 0103013f0csync_xfer=2c Vendor: SGI Model: SEAGATE ST31200N Rev: 9278
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sdb at scsi0, channel 0, id 3, lun 0
scsi : detected 2 SCSI disks total.
SCSI device sda: hdwr sector= 512 bytes. Sectors= 4226725 [2063 MB] [2.1 GB]
SCSI device sdb: hdwr sector= 512 bytes. Sectors= 2077833 [1014 MB] [1.0 GB]
sgiseeq.c: David S. Miller (dm@engr.sgi.com)
eth0: SGI Seeq8003 08:00:69:07:9b:35
Sending BOOTP requests.... OK
IP-Config: Got BOOTP answer from 169.238.83.43, my address is 169.238.83.19
IP-Config: Cannot add default route (-22).
Partition check:
sda: sda1 sda2 sda3 sda4
sdb: sdb1 sdb2 sdb3 sdb4
Looking up port of RPC 100003/2 on 169.238.83.43
RPC: sendmsg returned error 128
RPC: sendmsg returned error 128
RPC: sendmsg returned error 128
RPC: sendmsg returned error 128
portmap: server 169.238.83.43 not responding, timed out
Root-NFS: Unable to get nfsd port number from server, using default
Looking up port of RPC 100005/1 on 169.238.83.43
RPC: sendmsg returned error 128
RPC: sendmsg returned error 128
RPC: sendmsg returned error 128
RPC: sendmsg returned error 128
portmap: server 169.238.83.43 not responding, timed out
Root-NFS: Unable to get mountd port number from server, using default
RPC: sendmsg returned error 128
RPC: sendmsg returned error 128
RPC: sendmsg returned error 128
RPC: sendmsg returned error 128
mount: server 169.238.83.43 not responding, timed out
Root-NFS: Server returned error -5 while mounting /tftpboot/
VFS: Unable to mount root fs via NFS, trying floppy.
VFS: Cannot open root device 02:00
Kernel panic: VFS: Unable to mount root fs on 02:00
Other config info:
I'm using another Indy (marvin2) for the bootp/tftp/NFS server. My Indy for Linux is called argo.
hosts:
169.238.83.19 argo
169.238.83.43 marvin2
/etc/exports:
/dist/linux -rw,32bitclients
/etc/inetd.conf:
tftp dgram udp wait root /usr/etc/tftpd tftpd -l
bootp dgram udp wait root /usr/etc/bootp bootp -d
/etc/bootptab:
marvin2 1 08:00:69:0A:D5:44 169.238.83.43 vmlinux
argo 1 08:00:69:07:9b:35 169.238.83.19 vmlinux
Server SYSLOG output:
Jan 8 21:06:34 7D:marvin2 bootp[15713]: starting at Fri Jan 8 21:06:34 1999
Jan 8 21:06:34 7D:marvin2 bootp[15713]: (re)reading /etc/bootptab
Jan 8 21:06:34 6D:marvin2 bootp[15713]: reply to argo: boot file /dist/linux/mipseb/vmlinux
Jan 8 21:06:34 7D:marvin2 bootp[15713]: reply to client (ciaddr) 169.238.83.19
Jan 8 21:06:34 6D:marvin2 tftpd[4082]: argo: read request for /dist/linux/mipseb/vmlinux: success
Jan 8 21:06:42 6D:marvin2 bootp[15713]: reply to argo: boot file /dist/linux/mipseb/vmlinux
Jan 8 21:06:42 7D:marvin2 bootp[15713]: reply that IP address (yiaddr) is 169.238.83.19
Portmap info:
marvin2:chad 118 # rpcinfo -t marvin2 100005
program 100005 version 1 ready and waiting
rpcinfo: Program/version mismatch; low version = 1, high version = 3
program 100005 version 2 is not available
program 100005 version 3 ready and waiting
marvin2:chad 120 # rpcinfo -t marvin2 100003
program 100003 version 2 ready and waiting
program 100003 version 3 ready and waiting
marvin2:chad 122 # rpcinfo -p marvin2 | grep 100005
100005 1 tcp 1024 mountd
100005 3 tcp 1024 mountd
100005 1 udp 1026 mountd
100005 3 udp 1026 mountd
marvin2:chad 115 # rpcinfo -p marvin2 | grep 100003
100003 2 udp 2049 nfs
100003 3 udp 2049 nfs
100003 2 tcp 2049 nfs
100003 3 tcp 2049 nfs
--
-----------------------------------------------------
Chad Carlin Special Systems
Silicon Graphics Inc. 972.205.5911
Pager 888.754.1597 VMail 800.414.7994 X5344
chad@sgi.com http://reality.sgi.com/chad
-----------------------------------------------------
"His favorite Porsche was never the last. It was
always the next" Said of Dr. Ferdinand Porsche
^ permalink raw reply [flat|nested] 2+ messages in thread
* Re: boot vmlinux trouble
1999-01-09 5:29 boot vmlinux trouble Chad Carlin
@ 1999-01-10 0:23 ` ralf
0 siblings, 0 replies; 2+ messages in thread
From: ralf @ 1999-01-10 0:23 UTC (permalink / raw
To: Chad Carlin, linux
On Fri, Jan 08, 1999 at 11:29:22PM -0600, Chad Carlin wrote:
> Linux version 2.1.100 (root@alex3.med.iacnet.com) (gcc version 2.7.2) #29 Thu Jul 9 22:19:39 EDT 1998
[...]
> IP-Config: Got BOOTP answer from 169.238.83.43, my address is 169.238.83.19
> IP-Config: Cannot add default route (-22).
[...]
As I remember NFS root was broken in 2.1.100. .100 is dark history
anyway, maybe Alex can provide a newer kernel for HardHat anyway?
Ralf
^ permalink raw reply [flat|nested] 2+ messages in thread
end of thread, other threads:[~1999-01-10 0:34 UTC | newest]
Thread overview: 2+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
1999-01-09 5:29 boot vmlinux trouble Chad Carlin
1999-01-10 0:23 ` ralf
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.